How will you know when your water heater needs to be replaced? When its steel tank begins to leak. Conventional gas and electric water heaters have few external components, and none of them move, which makes these appliances quite durable. You may need to replace an ignitor or a temperature-and- pressure (T&P) relief valve occa- sionally, or in the case of an elec- tric heater, a heating element or thermostat. However, these com- ponents are inexpensive, and so simple that they make for easy change-outs. A leaky tank, on the other hand, often signals the bitter end. Steel tanks are naturally sus- ceptible to rust, and heat only exacerbates the problem. So why do most water heaters these days have steel tanks? Because they’re familiar and cost a fraction of the other designs on the market. Plus, manufacturers have long known how to mitigate the rust issue. The first line of defense is a porcelain tank lining, which is swirled in and baked on. The sec- ond is a sacrificial anode rod, usu- ally made of magnesium. These are typically less than an inch thick and about 42 inches long. They’re usually threaded into the top of the tank. The glass lining does most of the work, but it isn’t perfect, and most applications leave many tiny pin holes. This is where the anode earns its keep. Magnesium in this environment corrodes easier than iron, and as the anode corrodes, it sheds elec- trons, which are drawn to the pin- holes in the glass. As long as the
rod is in place, the tank won’t corrode. It’s a neat trick, but it has a shelf life—anode rods don’t last forever. Manufacturers make 5-year anodes and 10-year anodes, hence the 6- and 12-year tank warranties. Without anodes, tanks can rust through in as little as a year, depending on local water conditions. Soft water, by the way, is more aggressive than hard water. There’s a real opportunity here for the frugal homeowner. If you replace your heater’s anode when the tank warranty expires, or any time before the tank leaks, you could double the life of your heater for the price of a pizza with sodas. Home improvement centers and hardware stores sell replace- ment rods for $20 to $50. While not always easy, anode replace- ment is pretty simple. Look for the anode rod’s hex nut in the top of the heater. If you don’t see one, expect the anode to be part of the water inlet tube, which will require that you cut the water line con- nected to it. I’ll assume a stand- alone rod, independent of the inlet tube.
Extend the Life of Your Water Heater
By Merle Henkenius